Erhältlich:
Nicht auf Lager
Buch (Softcover): Fachbuch
The Electrician's Guide To Motors And Motor Controls
A Field and Classroom Guide for Electricians
Verlag:
Independently Published Unsere-Artikel-Nr.: P34846621
EAN: 9798187507870
Erhältlich:
Nicht auf Lager
Zustellung: Do, 08.10.2026
Versand: Kostenlos
CHF 67.50
Beschreibung
You replaced the motor. Why did it fail again. A good motor in a good installation should run for twenty-five years. When one dies at five, that is not bad luck. It is a symptom, and somewhere in the system is a cause. Finding it is the job. For most of the history of electric power, a motor was a motor and a starter was a starter, wired up and forgotten. That world is gone. Today the motor and the controls that run it are one system, and the load reaches back through the shaft and decides how hard the motor works, how hot it runs, and when it quits. The Electrician's Guide to Motors and Motor Controls. is a field and classroom guide to that system, written in plain, first-person language for the electricians, mechanics, and technicians who keep it turning, not for design engineers. It works the way the job works: from the nameplate to the starter, and from the symptom to the cause. Inside this guide:. How an induction motor makes torque: the rotating field, slip, and why the load runs the machine. Reading the nameplate: voltage, horsepower, service factor, and the code letter. Construction and wiring: enclosures, cooling, dual-voltage leads, and getting rotation right. Single-phase and three-phase motors: how they start, run, and burn up. The controls: contactors, starters, overloads, and the circuits that run them. Sizing, troubleshooting, and maintenance, with the author's own BARP and LUTA methods. Every chapter is built on real jobs from the field and marked with five clear callouts, Case File. , Key Point. , Field Hack. , Common Mistake. , and Warning. , so the hard-won lessons are easy to find and hard to forget. Written by Stan Turkel. , an electrical engineer with more than forty-five years in the field and over twenty-five years teaching the electricians and technicians who run motors across industrial, commercial, marine, and wastewater settings. Whether a machine will not start with production waiting, or you are teaching the next crew how to find out why, this is the book you keep on the bench. Part of Stan Turkel's Troubleshooting Series.
Spezifikationen
Sprache
- Englisch
Autor
- Stan Turkel
Erscheinungsjahr
- 2026
Format
- Buch (Softcover)
Anzahl Seiten
- 134